S-Chassis K-Frame/Caster mount weld in reinforcement plates Pivot Balls Click below:

Click below:

When tested on a dyno the GKTECH high-performance fan took less than half the time to cool down from 90 degrees to operating temperature (good for next time you're on the start line at the track)

or at all if extended too far out)

They eliminate axle tramp whilst also raising the subframe 10mm which helps to correct the roll center on lowered vehicles

Can also be fitted to an S13/180sx when installing rear drum brakes with the use of our drum handbrake conversion plate that can be seen here: https://au

S-Chassis K-Frame/Caster mount weld in reinforcement plates Pivot Balls Click below:The GKTech weld in K frame caster rod plates has been designed to help brace one of, if not the most necessary area on your S chassis. Caster rods put an immense amount of load on the K frame and the K frame itself flexes under load a visually noticeable amount. Our weld in plates will help eliminate this which will result in better overall handling and steering feedback. The added benefit is that if you ride over a ripple strip at the race track (or