MiniPro Voltage/Current Sensor Off Road Stand 24" 1s/2s balance charge lead

24" 1s/2s balance charge lead featuring 5mm bullet connectors and a 2mm balance bullet on the battery side

you will need to supply your own power leads

Reverse polarity identification

Wires exit the front of the unit instead of above the motors

recommend to use RX24 100W resistors with fans and heatsinks to cool them down):

MiniPro Voltage/Current Sensor Off Road Stand 24" 1s/2s balance charge leadThis is a redesign of the MiniPro 200A Current Voltage sensor. This sensor runs off a separate power supply than the power source you are using for the MiniPro. Operates off of 7. 5 15VDC, you will need to supply your own power leads. Solder the positive lead to the VIN+ and the ground to the VIN . Run the sensor in series with your power source for your motor to get the current and voltage information. Calibration of the sensor is done in the MiniPro