Gear Pinion Helical - 20T, Modula 1.0 - 8mm Bore Hole nut 2pc Gantry Plates (20mm Thick

2pc Gantry Plates (20mm Thick Plates) - These Gantry Plates can be driven using 20mm Linear Block Bearings and 16mm BallScrews with 40mm or 80mm HD extrusions

Perfect for powering MASSO Touch Controller and Sensors

Hot Wire Machines

This is heavy load linear guide way designed by circular-arc groove and structure optimization that are higher over 30% load capacity and rigidity than other similar ball type linear guide-way

Wrench Torque = 1

Gear Pinion Helical - 20T, Modula 1.0 - 8mm Bore Hole nut 2pc Gantry Plates (20mm ThickPrecision CNC gear pinion for the racks. They are helical tooth made out of ground steel, and pre drilled for 2 set screws at 90 degrees and hardened. The pinion specs are: Bore Hole 8. 0mm Modula 1. 0 Helical Tooth Hardened Ground C45 Steel Pre drilled Bore Hole (Please select the correct bore hole required) 20 Degree Pressure Angle 2 Set Screws at 90 degree OD = 22mm Flange OD = 16mm Total Width = 24mm Teeth Width = 12mm