EL wire starter pack - Aqua 2.5 meter (8.2 ft) [Discontinued] _ARD_CASE you must use a pullup

you must use a pullup resistor from the drive pin to your logic level to create the full waveform

and no external choke resistors are required making your design minimal

Since the display uses only 4 pins to communicate and has its own pixel-addressable frame buffer

analog voltage output (Vcc/512 volts per inch)

we suggest a 3

EL wire starter pack - Aqua 2.5 meter (8.2 ft) [Discontinued] _ARD_CASE you must use a pullupA little bundle to get you started! This project pack contains: 2. 5 meters (over 8 ft) of high brightness, long life EL wire in Aqua, the brightest and best looking EL color we carry. 2. 5 meters is the maximum amount for the pocket driver it is cut and soldered so it's ready to go! Pocket EL inverter runs on 2 AA Alkaline or rechargeable batteries (not included) 2 inches of heat shink, both 1 8" and 1 4" for protecting the EL wire after soldering if